CAUTION: This debug script is for advanced users only. Its Purpose is to remove all formatting and partitioning information from your hard disk when FDISK is unable to do so. THIS WILL REMOVE ALL DATA AND PROGRAMS FORM THE DRIVE.
1. Create a MSDOS bood disk with Debug
2. At DOS command prompt type the following: Debug[Enter] (Where enter is to press the enter key once)
NOTE: Type the following bolded text only. You will recieve an error if you type anything other than the bold text. The non-bolded text represents what will appear on you screen once you press [Enter] after each command.
-F 200 L1000 0 [Enter]
-A CS:100 [Enter]
xxxx:0100 MOV AX,301 [Enter]
xxxx:0103 MOV BX,200 [Enter]
xxxx:0106 MOV CX,1 [Enter]
xxxx:0109 MOV DX,80 [Enter] NOTE: ( --- "80" for hd0, "81" for hd1)
xxxx:010c INT 13 [Enter]
xxxx: 010e INT 20 [Enter]
xxxx: 0110 [Enter] -G [Enter] "Program terminated normally"
3. Turn off the computer.
On the next startup the hard drive will need to be partitioned and formatted.***
Subscribe to:
Post Comments (Atom)
-
This video tutorial demonstrates how to easily setup your Raspberry Pi as Android TV A big shout out to KonstaKang for providing a modified ...
-
This video demonstrates how to run Windows XP on Single board computers like RaspberryPi, TinkerBoard etc. Follow commands below to boot the...
-
How to modify BCD when installing a previous version of Windows onto a computer running Windows Vista Installing an earlier operating system...
How to add Wireless capability to legacy printers using Raspberry Pi
This video tutorial demonstrates how to easily add wireless print capablity to your wired legacy printers using your Raspberry Pi. We hav...
No comments:
Post a Comment